Written Instructions
Dry fitting the mount to the helmet
Before taking off the red backing of the 3M tape, place the mount onto the bottom chin area of your helmet. Slide it up and down until you feel it fit into place. We strongly recommend checking the product page images of your helmet’s make and model, as it shows the correct mounting position to ensure the best fit and adhesion.
Cleaning and degreasing the helmet mount location
Using the alcohol pad provided, clean the front area of your helmet where you intend on placing the mount. (If you have any stickers or vinyl wrapping on the area you intend on attaching the mount, we strongly suggest removing it before cleaning and attaching the mount).
Attaching the mount to the helmet
Now that you have found the perfect spot for your mount, and you have cleaned the area of the helmet, you are ready to peel off the protective red layer of the 3M tape. Now heat up the piece of 3M tape with a heat gun or hair dryer. Once the mount is warm, push the mount onto the helmet, hold it down for 3 minutes. The mount will now have adhered to your helmet. Please give the 3M tape 24 hours to bond to the helmet. (Be careful not to melt the 3M tape).
Please note: Each MotoMount is specifically designed to suit the shape and features of its corresponding helmet make and model. Incorrect placement may compromise adhesion and result in the mount detaching. MotoMounts cannot accept responsibility for mounts that come off due to improper installation.